Hello Makerworld!
 

• Model description:

New addition to my MindBlockz collection, the Pillager was pretty easy to make since I used most of the parts and form from the Golem. This collection grows every week and I will making more of this soon!
The instructions manual is good to be used for this model as I have already figured all the mistakes I was making on the other models.
Be sure to see those and give them a like :)

• Important to know:

1. As I mentioned before, it is super crucial to follow all the print profiles because they are the best after a lot of testing for printing the bricks, you guys are more than welcomed to post changes if you come up with something but understand that Remixes will not be allowed since this project was very hard to design and test. It is also needed to clean your print bed and level your printer beforehand for the best outcome
2. It is recommended to have pliers or a knife/sharp object to clean out the inner brims after the parts are taken off the bed as well as glue for better adhesion on some rough connections.
3. For a better model quality I recommend using a layer hight of 0.12 or below, I used 0.20 on mine just for testing

• Model Updates:

Version 1.1.9 Original version