This is a portable Raspberry Pi and Software Defined Radio (SDR) case. 

There are different configuraitons available and an optional Waveshare 2.9in E-Ink display can be fitted.

Further information, links to all recommended parts, software for a portable ADS-B receiver setup and wiring instructions can be found on github.

Options:

Besides the provided print profiles, it is possible to download individual STL files (use the drop-down button next to the download button) with some different variations too the default print profiles:

• Case Front: 
  • Display - This has a slot for a Waveshare 2.in e-Paper Module
  • No Display - This has a blank front plate
• Lids:
  • With Support - These lids require support material to print properly (recommended).
  • No Support - These lids don't need support material to print, however the case will end up slightly less sturdy.
• Lid Tops:
  • [A] Variant - These Lids do not have a hole for a switch.
  • [B] Variant - These Lids have a 6mm hole for a toggle switch.

Printing

All parts are intended to be printed in the provided orientation. 

• Recommended print settings:
  • Layer height: 0.2mm
  • Outer Walls: 2 loops
  • Infill: 15-25% Gyroid
• Supports:
  • For the Case and Lids - No Support, no supports are required. 
  • The Lids - With Support require support.

Required Parts:

Printed:

1x Lid Top

1x Lid Bottom

1x Case Front

1x Case Rear

Hardware:

8x M4 threaded insert for 5.6mm hole size

8x M4x12mm allen key bolt

4x Mounting screws for the Pi (M2.5x5mm or similar size)

Electronics:

1x Raspberry Pi (3/4/5)

1x SDR - Nooelec NESDR SMArt recommended, but similar sized one will work as well

1x USB-A to USB-A extension cable (20-30cm)

1x USB-C panel mount (Amazon)

1x USB-C to Micro-USB cable (20-30cm)

1x (optional) Mommentary 3 Position Toggle Switch - (ON) - OFF - (ON) - with 6mm mounting hole diameter

1x (optional) Waveshare 2.9in E-Ink Display Module (Waveshare)

1x (optional) GPS Module - Beitian BN-220 or similar recommended

Happy printing!