N64 Controller and game stand

Hey everyone! 

I created a Mario-themed, controller and game stand for the N64 console. One of my buddies owns a gaming store and I made these for him, they've been pretty popular so I figured I would share it here too and contribute to the community.

There's about 6 different prints in this model, but assembly is pretty easy. I designed it so that you can fit 4x of each print on the build plates, (except for the wire hooks, you can only fit 3 pairs flat), so if you wanted to print a set of 4 at a time you can. 

The text has to be printed upright since its curved, so I recommend a small layer size there. I have the recommended layer sizes on the names of the plates in the file.

There's a short assembly manual attached. There's not a whole lot to it, mostly just glue things and file down some of the text to make it prettier.

The wires should take about 8 or so wraps around the hooks. Then thread the plug underneath the piranha and insert it into the green tunnel. It should snap in nicely. Depending on how worn the tabs on your plug will determine how tight the snap is but it will be pretty loose either way by design.

This if my first upload, so looking forward to feedback. Please post your photos too! Enjoy :)