This is my take on a basic hanging plater. I was going for a clean and modern aesthetic, but also wanted to incorporate both wood and marble PLA's into it. The Different sizes are just straight rescales of the original. I am including a Non-AMS version, though admittedly I have not tested that specific profile. There is a minor issue with the bottom of the exterior pot, on the inside I just couldn't bridge it well and the layers just weren't clean. Ultimately it doesn't effect the pot or its outward appearance, so rather than wasting material on supports I have opted to leave it as is. Feel free to add supports if it is a problem for you. 

The Insert is optional. It has some holes in the top to help get a hold of it once in place. It has a flat base to allow it to sit upright in tube or sink for watering. The drain holes are a little large, this is a personal preference for me as I like to add paper towels or coffee filters before my dirt to help retain soil. The holes are large to allow adequate drainage quickly.  

The measurements on these pots come out to about 7", 5", 3.25", 1.5"

Post process for me was just some light sanding. I did decide to apply a wood stain to the Wood PLA to see how it effected the fibers, I am very pleased with the outcome and suggest trying it yourself!

For hanging it, i just used some rope and followed the directions in this video. Do take note that when they make the loops at 0:10 which rope is on top, I recommend pausing it at the 10 second mark and looking at it closely.

I Hope you enjoy! Feel free to drop me any questions or concerns and I'll try to address them quickly!