3D Printer Cable Shortener

Do you have lots of unnecessary cable hanging off the back off your printer? This cable shortener was designed to declutter your workspace by getting rid of unnecessary cable. It works by the cable being wrapped around two knobs and a cover being placed on top to conceal it.

IMPORTANT

Print the first plate in PETG to make it stronger.

How to set up

First, find out where you want it on you wall and make it level. (make sure it isn't too close to the outlet or the cable won't have room to bend)
Take some screws and screw them in through the knobs.
Carefully wrap your cable tightly around the knobs.
Push the cover on so the middle prongs squeeze through the hole in the center of the case and the ends of the cable fit in the notches built in to the case.
Make sure that everything is to your liking and enjoy :)

Descrição