This is a realistic OVERHANG settings test. The other models on MW are really COOLING tests, the layer time on those models is less than the minimum, so they are artifically SLOWED!

This model is designed to NATURALLY converge or exceed most minimum layer times for Filament profiles. That means you are actually testing your OVERHANG SPEED from the Process settings, not the COOLING settings from the Filament profile - EXACTLY what you want! 

3 Features:

1. Long Run - The middle part will benchmark your maximum overhang speed
2. Small Island - The curved islands will validate your settings also work for small island overhangs
3. Miminum Wall Thickness - The back thin wall is about 1mm thick and will validate your other SPEED settings are fine during this whole process. You don't want to create a profile that's ONLY good at overhangs, but goes crazy on other fast sections.

This part should allow you to test all of your speed settings for the outer walls of a model. The angles of the walls are 30 to 60 degrees.