6-May-2026 - Model stands the test of time. 2,100 printing hours later, and the model holds up fine. No signs of damage to the cable.

1-Nov-2025 - Updated profile to optimise printing.

A1 Side Cable Tamer

The A1’s side cable always bugged me — at the lowest X‑axis position it flares out, rubbing or snagging on anything beside it. I wanted to put my filament dryer next to the printer to save desk space, so I designed this cable tamer to keep the cable tucked neatly in line with the X‑axis motor. It also helps if you want the printer closer to a wall or in a corner.

I couldn’t find any designs that solved this, so it was a good excuse to learn Fusion 360 and make my own. In the photos you’ll see the cable with and without the tamer, plus a shot at full height to show it still moves freely.

Printing

• Printed with PLA+
• On the OEM Bambu textured PEI plate, thin sections may lift — I recommend enabling brims (handy tip:  Diluted PVA wood glue works wonders to get prints to adhere to the bed).
• Minimal supports required; they pop off easily
• Clean bed + run a levelling calibration for best results

Fit & Use

• Snaps securely into the two side holes at the bottom of the right-side A1 pillar.
• Tested for many hours of full height prints and width printing with no issues or binding.

This keeps the cable tidy, prevents rubbing, and makes desk or wall placement much easier.