Tie Carousel V2

This is an updated version of my Spool Tie Carousel! Updates incorporated from feedback received:

• removed spool
• corrected the threads
• size it down/fit onto one build plate
• added storage tray space for tie accessories like pins, tacks, bars, etc.

A few things to note:

• PETG is the preferred plastic here. This is due to the tight fit of the hanger (by design to minimize the “swinging” effect.
• Rotation is smoothest when the ‘load’ of the tie weight is balanced, so if you only have a few ties, you need to space them around to get smooth rotation
• If there is a squeak from ball and socket joint, a single drop of lubricant should take care of it (I used hair clipper oil I had on hand)

Assembly

This should be pretty obvious as I went with a simple screw together connection.  Here are the steps listed in order:

1. Print 
2. Thread the hanger cap onto the carousel cylinder.
3. Snap fit the hanger onto your 25mm/1" closet rod (Be careful here as the fit is very snug by design. PETG should perform just fine)

Specs 

• Tie Capacity = 30 ties (Sadly, I have more ties than this…)
• Hanger Size = 25mm or 1" (I think this is a standard closet rod)
• Fully rotatable print-in-place ball style joint