本套积木由 122 块积木块组成。为方便在 3D 打印后进行组装，每个凸粒上都标注了数字用以示意安装顺序。。

This set of building blocks consists of 69 pieces. To facilitate assembly after 3D printing, each stud is marked with a number to indicate the installation sequence. 

打印前准备工作Preparation Before Printing
清洗打印板，并均匀喷上胶水，以防止较小积木块在打印中脱落。如有烘干箱，建议对耗材进行烘干处理，因为受潮的耗材可能会导致榫卯结构出现轻微变形，从而使得积木难以插入。
Clean the printing plate and spray glue evenly on it to prevent smaller building block pieces from detaching from the printing plate during the printing process. If there is a drying oven available, it is recommended to dry the printing consumables, This is because the damp consumables may cause slight deformation of the mortise and tenon structure, making it difficult to insert the building blocks. 

打印后处理工作Post-printing Treatment
仔细辨认凸粒上的数字，并按照数字将积木进行分类摆放。为了区分方便，数字6、8、9的右侧加注了小圆点。

Carefully identify the numbers on the protruding grains, and classify and place the building blocks according to the numbers. For the convenience of distinction, small dots are added to the right side of the numbers 6, 8 and 9.

组装要点Key Points of Assembly

按照数字顺序依次安装积木，并且所有数字应始终保持同一方向对齐。
在组装过程中，按照步骤将积木块紧密咬合到位。如果由于打印公差导致难以组装，可以使用合适的工具（如橡胶锤）辅助安装，但严禁敲击积木块的凸粒部分。

Install the building blocks one by one in numerical order, and all the numbers should always be aligned in the same direction.

During the assembly process, make the building blocks fit tightly in place according to the steps. If it is difficult to assemble due to printing tolerances, appropriate tools (such as a rubber mallet) can be used to assist with the installation, but it is strictly prohibited to strike the protruding grain parts of the building blocks.

儿童组装时需有成人陪同，避免误吞细小颗粒。

An adult should accompany children during the assembly process to prevent them from accidentally swallowing small particles.