This is a prybar multi-tool. It is a 3-in-one tool. It is a pick, a screwdriver, and an opening tool. It also has the slots for magnets on the top. This allows quick and easy storage when not needed. It uses ¼ inch hex bits. There is a recession for adding a 4x2mm magnet on the bottom of the hex bit drive. This is needed to make proper use of the hex bit drive. The entire tool take 3 magnets. You can make 6 tools off of one 20 pack of magnets. These are great tools for opening plastic panels and picking at silicone caulk. I use it to take panels off of my Dualsense. The pick will pierce paper. It can be resharpened by cutting at a 45 degree angle. Make sure your magnets are oriented correctly. This tool is a perfect addition to your workshop. If you have any suggestions to improve this tool, or an idea for another tool, drop a comment below. If you like what I do, please drop a boost. It helps, keep my printers running! Thanks!