Vertical Laptop Dock – Minimalist Stand for Desk Organization

Keep your workspace clean and efficient with this 3D-printed vertical laptop dock. Designed for minimalism and stability, this dock securely holds your closed laptop in an upright position—perfect for pairing with an external monitor, keyboard, and mouse.

Features:

• Low-profile footprint for clean desk aesthetics
• Minimum thickness: 12.40mm
• Maximum thickness: 87.60mm

Assembly Requirements:

• 4x M4 heat-set inserts
• 4x M4 8mm bolts (length depends on mounting surface)
• 4x M4 washers (optional, recommended for better bolt seating)

Assembly Instructions:

1. Press the heat set inserts into the fin ends.
2. Align the holes with the slots in the base and hand tighten the bolts. Tighten them to the point where the ends no longer slide easily but can still be adjusted.
3. Now take your laptop and seat it into the dock, and adjust to the width.
4. Once you have the desired width carefully lift the laptop out, and turn the dock around and tighten all the bolts in an X pattern.

Note: If your bolt head is very small I would recommend using an M4 washer. Hand

Print Settings:

• Material: PLA, PETG, or your preferred filament
• Layer height: 0.2mm recommended
• Infill: 25% or higher
• Supports: Not required

This is a practical addition for any desk setup—especially ideal for MacBooks and other slim-profile laptops. Print, assemble, and tidy up your workspace in style!