Hello everyone,

Our long-awaited flagship printer H2D has finally arrived, and we're looking at how we can improve it with additions.

So we created this emergency stop release.

H2D comes with a so-called "safety key" located on the back of the printer.
If you pull out the safety key, the printer remains without power and automatically shuts down.
As our printer works constantly even when we are not around, we made an emergency stop release that is easily visible to everyone.

It is very easy to print, without support.
Easy to install in a few steps:
1. Turn off the printer
2. Pull out the safety key
3. Slide your newly printed "Emergency stop release" onto the safety key.
4. Put everything back on the printer and turn the printer back on.

EMERGENCY STOP RELEASE IS ONLY USED IN EMERGENCY CASES!

You have two ways to withdraw:
1. Is to pull it out towards the back, the same as the standard safety key
2. To pull the emergency release towards you and the safety key will be pulled out (this is a faster way, but not recommended in order not to break the key)