This is a bee hotel to help your local wild bees.

The roof and the attic can be removed completely for maintenance.

The attic can be used as a drawer to change the contents.

The bee hotel can be hung on the wall with two screws. There is a separate wall hanger inside the print profile.

Just print the hanger and mount it on your desired wall. Afterwards you can slide the bee hotel from the top inside the hanger.

To make the bee hotel species-appropriate, 14cm/5,5 inches long nesting tubes made of bamboo or other natural material are required.

Printed in PETG (recommended for outside use)

What you need:

~40x bamboo nesting tubes (14cm/5,5 inches long, 4-8mm diameter)

1-2x screws (3,0x20 w. countersunk head)

Dimensions:

Base of house: 90x151cm

Total height: 14,6cm (center of roof)

Printing times:

8,5 hours

Filament needed:

284g

Screws needed:

3,0x20 - Other screws are also sufficient.

One screw should be sufficient enough to hold the bee hotel. I used myself only one screw.