Adorable Minion fidget clicker!! 

It uses a Outemo Switch from AE but it should be compatible with MX Switches.

IMPORTANT: please print the bottom part and check that your switch fits within the square hole made for the switch.

INSTRUCTIONS: 
1.- After checking that the switch fits, print the top part.
2.- As it is quite a snug fit, it is better to firstly insert the switch into the top cross hole as shown in the following picture:

3. Line up the bottom part with the “F” letter on the same side as the front part of the top as shown in the picture

4. Press both parts so the switch attaches to the bottom part. You might have to press it couple times to smooth it.

Please consider uploading a picture of it if you print it! We love seeing our models printed and it gives us great courage to continue learning and creating new stuff.

Check out my Eastern Minion Egg Container on my profile!

Many thanks!