Just a Wolverine hueforge I threw together and hope you all can enjoy it too!

Print at 100% infill with a layer height of 0.08mm with a base layer height of 0.16mm

The model is 200x200mm in size

You may print at higher layer heights below the Min Depth of 0.48mm

The Max Depth is 3.5mm and the Actual Depth is 3.6mm

Filaments Used:

PLA Basic Black Transmission Distance: 0.3

PLA Polyterra Sapphire Blue Transmission Distance: 3.5

PLA Polyterra Savannah Yellow Transmission Distance: 6.5

PLA Polyterra Cotton White Transmission Distance: 5

Swap Instructions:

Start with Black

At layer #12 (1.04mm) swap to Sapphire Blue

At layer #20 (1.68mm) swap to Savannah Yellow

At layer #30 (2.48mm) swap to Cotton White for the rest.

(It takes a long time to slice and is a relatively long print too)