Version 4 is out, it uses the new Multiboard bolt locking that are able to hold even more weight

Sturdy sledgehammer/hammer holder for Multiboard is made to hold a 1.5 kg (3.3 pounds) hammer. But the holder can take a lot more weight.

Spacing between the multiboard and the “fingers” is 44.8 mm.

Multiboard is moving away from the “old” raised snaps and going with the new flush snaps. Version 4 also use the flush snaps and the new improved bolt locking.

Size from edge to “fingers” aka. where the hammer rests:

• v1 + v2 = 46 mm
• v3 = 42 mm
• v4 = 44.8 mm with flush mount snaps

To mount the holder on Multiboard you need the following for mounting

version 4

• 2 pcs - Flush Heavy Weight-Bearing Hook Snap - 1 on top of each holder
• 2 pcs - Flush Snap - 1 on bottom of each holder
• 4 pcs - Folded Locking Bolt (2 for each holder)

I recommend using the following print settings for version 4 (or use the attached 3mf file):

• walls: 6 loops
• infill: gyroid, 10%
• no supports

version 1-3

• 2 pcs - Heavy Weight-Bearing Hook Snap - 1 on top of each holder
• 2 pcs - Moderate Weight-Bearing Snap - 1 on bottom of each holder
• 4 pcs - Small Thread - Multipoint (2 for each holder)

I recommend using the following print settings (or use the attached 3mf file):

• walls: 3 loops
• top and buttom shell thickness: 1 mm
• infill: gyroid , 15%
• no supports

Multiboard is created by Jonathan from Keep Making - www.multiboard.io