After searching Thingiverse and other sites, I couldn't find a lightweight and minimal camera mount suitable for my Logitech C615 and C920, so I designed one myself. This mount prints in under an hour at 60mm/s.

The hole size is designed for the most common camera mounting threads, 1/4"-20 UNC, with a 6.3mm diameter, providing a slight grip for a secure fit. Standard 1/4" threads are 6.35mm in diameter, so this design allows for better hold.

This uses just 8g of material, costing approximately $0.10, and was printed in PLA.

Print Settings

• Printer:

  Ender 3

• Supports:

  Yes

• Resolution:

  0.2 - use 0.1 for screw

• Infill:

  10-20