Fully printable tool-less brio/lillabo train tansport wagon

The carts can either be connected by 3d printed rings and hooks, or additionally, a 5x5mm round magnet can be inserted

Also check my other trains and rails:

Coal wagon: [https://makerworld.com/en/models/1267820-fully-printable-brio-lillabo-compatible-train-cart#profileId-1293900](https://makerworld.com/en/models/1267820-fully-printable-brio-lillabo-compatible-train-cart#profileId-1293900)

Articulated tracks and more: [https://makerworld.com/en/models/1267814-various-generic-and-custom-brio-tracks#profileId-1293895](https://makerworld.com/en/models/1267814-various-generic-and-custom-brio-tracks#profileId-1293895)

Passenger wagon: [https://makerworld.com/en/models/1267753-fully-printable-brio-compatible-train-wagon#profileId-1293822](https://makerworld.com/en/models/1267753-fully-printable-brio-compatible-train-wagon#profileId-1293822)

Steam locomotive: [https://makerworld.com/en/models/1267703-brio-compatible-steam-train-fully-printable#profileId-1293773](https://makerworld.com/en/models/1267703-brio-compatible-steam-train-fully-printable#profileId-1293773)

The internal mechanism of the wagon is supported by custom support with a PETG interface layer. If you are unable to provide petg, It will print fine but it will lose some functionality

Assembly is relatively straightforward:

1. The carriages come in two halves that can be snapped together with a dovetail. 

2. 

3. 

4. The assembled carriage can be screwed onto the main body with the provided printed screws. Hand tightening is enough, but a flathead screwdriver can also be used.

5. 

    

6. The connector hook and rings can be press-fitted in (or glued if the tolerances do not allow the former). The same is true for the magnet if it is chosen over the hook.