OneBlade Charging Stand 

-Allows the blade to charge while still being easy to grab

-Walls allow the blade to slide back into charger with ease

-Smooth two blade holders

-Plug Holder

-Additional comb/carrier holder

-Outlet charger holder 

-Wire slot to allow stand to sit flush

Print Quality

I'm relatively new to 3D printing, I used Overture PETG as the filament rather than Bambu Lab's because I thought they were all kinda the same but yeah that's probably why there are little layer imperfections but other than that came out good (and works) and I'm ready for my next project. I used PETG but PLA can be used, like I said not fully aware with all the slicer settings but yeah, I used Overture and reduced the speed, but the modification of speed is not saved in the 3MF, I just put it as Generic PETG.

Alright cool, yeah. 

Allow adaptations of your work to be shared?

As long as others share in the same way

Allow commercial uses of your work?

No