Description
LA STAMPA è COMPOSTA DA SOLO TRE OGGETTI, TUTTI I PIATTI CHE VEDETE SONO SOLO ED ESCLUSIVAMENTE PER SCEGLIERE UNA PERSONALIZZAZIONE CON IL PROPRIO MARCHIO PREFERITO.
The tolerance of the fit between the arm and the head varies depending on the material and the colour, so if there is too much play, a drop of super glue is needed to prevent it from falling out when the helmet is removed.
La tolleranza dell'incastro tra il braccio e la testa varia in base al materiale e dal colore, per cui necessita se rimane troppo gioco di un goccio di super attak per evitare che cada quando viene rimosso il casco
I made this helmet holder with the perfect inclination of the arm, in addition I have already created the heads with the logos of the best motorcycle companies so you can customize your helmet holder. To complete the print you need three prints: Body / interior / head as desired. / Ho realizzato questo porta casco con la perfetta inclinazione del braccio, in più ho già creato le teste con i loghi delle migliori casa motociclistiche in modo da poter personalizzare il proprio porta casco. Per completare la stampa servono tre stampe: Body/inster/head a piacimento.
- For assembly you only need two 6 mm wall plugs with their corresponding screws.
- For greater convenience in tightening the screw at the bottom, it is recommended to use a “hub” screwdriver (the short ones)
- Per il montaggio necessitano solo due tasselli da muro da 6 con le sue relativi viti.
- Per maggiore comodità a stringere la vite in basso si consiglia di utilizzare un cacciavite “mozzo” (quelli corti)
Porta casco da parete/ wall helmet holder
Published on Mar 29, 2025