This is a cake pop stand that can be used at festivities. The model is round to be the center piece on a table and can hold up to 31 cake pops where the straws have a maximum diameter of 4mm. The cake pop stand itself is 23 cm in diameter and 11 cm high. 

The cake pops are set at a angle of 10 degrees to pop out a bit more. 
 

Recommended print settings:

•  3 or more walls
• Gyroid infill @ 5% or higher. This is to ensure some weight when the cake pop stand is empty on 1 side. 
• Adaptive layers to speed up print time whilst guarding quality