🧡Commercial License Membership🍰

👇

[https://www.patreon.com/c/BakeShopMakes](https://www.patreon.com/c/BakeShopMakes)

[https://buymeacoffee.com/cinnamonbunmakes](https://buymeacoffee.com/cinnamonbunmakes)

For best results use 0.2 nozzle if possible, but 0.4 also works great (The pictures show the model printed with a 0.4 nozzle)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

    Swap Instructions:
Start with Black
    At layer #6 (0.56mm) swap to Lilac Purple
    At layer #10 (0.88mm) swap to Grass Green
    At layer #14 (1.2mm) swap to Marine Blue
    At layer #19 (1.6mm) swap to Sakura Pink for the rest.

No AMS No Problem Just put A PAUSE on the layers where a color change would be shown in picture #2👆

How to do more than 4 colors on a single AMS?

Always start the print from either Bambu Studio or Bambu Handy App - This will allow you to map the rolls of filaments to a certain slot in the AMS:

Now map the first 4 colors (which should already be inserted in the AMS to Slots 1 - 2 - 3 - 4
Once that's done move to mapping colors 5 - 6 - 7 - 8 to respectively AMS Slots 1 - 2 - 3 - 4 again!

as needed for how many colors you will need, (In the picture 👆 I would only need to map out the white).
 

This will allow you to Change the rolls of filament once the printer is done with that color.
For example, in the picture above once we are done with the Black color (Which is usually first) we are going to remove the black roll (you can do that while printing) Change it with White.  🪄 You can do that with as many colors as you need!

🐕YOU CAN PLACE A PAUSE ON THE LAST LAYER OF COLOR 4 TO AVOID HAVING TO BABYSIT THE PRINTER. ONCE PAUSED CHANGE 1-2-3 WITH 5-6-7 AND RESUME. IF YOU NEED MULTIPLE PAUSES YOU CAN DO THAT TOO 🐕