Created this simple panel mount to be able to have an external HDMI jack on an EVO64 machine. This can be used on any panel that has a thickness no more than 2.75mm. It requires an 18mm hole to be drilled into the panel to be mounted on.

The Mini HDMI cable used to design is from amazon at this link. Note this is not an affiliate link and I receive no compensation from anyone ordering through this link.

[https://www.amazon.com/dp/B00S6IBNIQ](https://www.amazon.com/dp/B00S6IBNIQ)

The retainer nut will only thread on in one direction, so if it doesn't seem to be threading on then flip it around and try the other side.

Print Settings:
Layer Height: 0.15
Supports: No
Infill: 15%