Was looking for a Bat Cave and came upon this model. Seen the request in the comments to make it smaller/ easier to print. So i reworked a few things and made it more "Print Friendly" with minimal supports. I Cut it into 4 parts which were printed on the Bambu A1. I printed at .28layer height. It is scaled down to fit a 1.5inch Bat Mobile on the right platform/ramp. I used Tree supports. The Bat Logo on the left platform is a extra part that is not grouped with the main part. I also added alignment pins. I used e6000 contact cement for a permanent bond. The pins are a nice snug fit so glue is not needed.

[https://www.thingiverse.com/thing:2589413](https://www.thingiverse.com/thing:2589413)