3D model FULLY Printed Clicking Keycap Fidget by JoeyAW on MakerWorld

Description

This keycap fidget doesn't require any other parts, including switches. It uses a spring with a unique clicking mechanism. Glue is not required, but is heavily recommended. Please don't complain about it not working if you didn't use any glue.

Assembly Instructions

Glue the small tab to the base and insert the two springs together

Put the two springs in their designated slots on the base. It is recommended that you **GENTLY** bend the piece coming down from the right spring towards the left spring to line it up with the base tab.

Slide the cover onto the base. It is recommended that you put glue around the edge of the base so that it stays in place better, but do this **after** you test that it works.

MakerWorld

FULLY Printed Clicking Keycap Fidget

JoeyAW

Published on Mar 22, 2025

3,946

Likes

15,719

Downloads

7,002

Collections

11,195

Makes

Category Other Toys & Games