ABS PRINT RECOMMENDED

This is a bracket/Adapter system that I design specifically to print while drying or after drying filament in my Polydryer straight to my p1s (should for for x1)

The issue that I had after printing the AMS riser V2 was that It was too tall to easily print from my poly dryer if I wanted to use TPU for example (cannot use AMS for that)

Additionally I was annoyed that when you dry Filament and want to seal up the box with the included rubber feet, it no longer fits well on the dryer anymore. I printed little adapters for that was well. Also, has a little vent just in case there is still warm air venting out.

The bracket has Holders for both my printed adapters, the spool tube and included feet when the dryer is being used.

It also features extra tabs to support it again the printer.

Note: base is locked in by sliding it into the screw holes in the bottom of the unit, making for a super stable fit. Keep this is mind if you do not print it in ABS as the clearance allowed by the shrinkage of the abs may not be enough with PLA and it wont work for other models or dryers.

It is a relatively easy print. I don't recommend you change the print profile too much as I did tune it in pretty well. If you want changing the Seams to random instead of aligned may look a little cleaner.

Also if this seems like to much feel free to just print the little adapter feet! they work well all on their own and you can still easily print it from a nearby surface.

Here are links to the products and other models used in the project Happy printing!

Here is the AMS riser V2 that I printed.

[https://makerworld.com/en/models/133452-ams-riser-v2?from=search#profileId-155321](https://makerworld.com/en/models/133452-ams-riser-v2?from=search#profileId-155321)

Here is also a link to the poly dryer i purchased.

[https://us.polymaker.com/products/polydryer](https://us.polymaker.com/products/polydryer)

The PTFE splitter in the background

[https://makerworld.com/en/models/18174-the-smoothy-y-splitter-connector?from=search#profileId-17021](https://makerworld.com/en/models/18174-the-smoothy-y-splitter-connector?from=search#profileId-17021)

I printed the Riser and bracket out of ABS but it SHOULD work with PLA as long as they are both printed with the same material.