Fried egg yolks -Click  Click!

Instructions
Print the Clicker Tool profile first to test the fit of your keycaps. If it doesn’t fit properly, enlarge the Clicker Tool by 1-2% until it fits just right. Once you have the perfect fit for your printer settings and keycap, enlarge both the top and bottom pieces by the same percentage.

Updated on December 13, a limiter was added to prevent the egg yolk from falling out.

You'll just need to insert 1 "clicky" key switches which are easy to buy from amazon or adafruit or microcenter etc.

It can be used as a refrigerator magnet and requires 3 4*2 magnets

Note, the cross part of the key switch must be pressed all the way to the bottom with force; press all the way down. Any poor rebound is caused by improper installation.

This video introduces the assembly process.

More clicker-related models, click the image or link below to view directly

[https://makerworld.com/zh/collections/19470239-clicker-collection](https://makerworld.com/zh/collections/19470239-clicker-collection)