This mold is designed to make homemade ice cream in the shape of an Easter egg.

It consists of three parts: the bottom half of the egg, the top half with a hole for the stick, and the ice cream stick itself.

The mold is approximately the size of a regular chicken egg.

The mold is intended to be printed from TPU, alternatively, you can try printing it from PLA, but in that case, do not use it for making ice — expanding water during freezing may crack or break the rigid PLA mold.

Usage Instructions:

1. Pour your ice cream mixture (e.g., yogurt, juice, or cream-based mixture) into the bottom half of the mold.
2. Insert the stick through the top half and close the mold by connecting both halves.
3. Place it in the freezer.
4. Before removing the ice cream, briefly run warm water over the mold to release the ice cream easily.

Alternative Use:
Without the stick, the mold can be used to make egg-shaped ice cubes (only if printed in TPU).