Dancer:

I'm thrilled to introduce a new collection I am starting called 'The Dancer,' a collection of artwork that utilizes fire, water, smoke and so forth to create an illusion of fantastical dancers.

3/25/25: @rickhey  shared a bluer version you can print, by adding a darker blue layer before the cyan(any lighter blue) and the results are great. Here is either swap instructions you can use to get this similar result:

Swap Instructions:
    Start with Black

    At height depth (1.20mm) swap to Blue(Darker Blue)
    At height depth (1.36mm) swap to Cyan (lighter Blue)
    At height depth (1.52mm) swap to Jade White for the rest. 

or 

    Start with Black

    At height depth (1.20mm) swap to Blue(Darker Blue)
    At height depth (1.36mm) swap to Cyan (lighter Blue)
    At height depth (1.60mm) swap to Jade White for the rest. 

Water Dancer

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. 

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Cyan Transmission Distance: 4
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 3 unique filaments

Swap Instructions:
    Start with Black
    At height depth (1.36mm) swap to Cyan
    At height depth (1.52mm) swap to Jade White for the rest.