I shot an egg into space … or 30ish feet what ever comes first. This Bunny Easter Egg Rocket is made to be used with my Stomp Rocket project or the Dinosaur Stomp Rocket found on Amazon. It's basically an egg wearing bunny ears sitting on top of a rocket that you can launch into the air. This really should fit any type of stomp or air rocket system that has a tube smaller then 18.5mm in diameter tube. 

Video of it Flying:

Printing:

You will need supports in the tube. My suggesting for getting the supports out is just to stick your tweezers or needle nose plyers in and twist. I've printed 10/15 of these rockets and that's the easiest way to remove the tube supports.
 

If you aren't using my .3mf, the slicer will most likely suggest supports on the left ear, you don't need them (Or at least you don't on a P1S).

If you like me and like to mess with your flushing volume multipliers, I've included a picture of .6 multiplier vs. a 1 multiplier. The color blend is pretty noticeable, so I'd suggest sticking with a 1x multiplier. On the flip side, this is an out door toy that's meant to get dirty so does it really matter.

Other Thoughts:

The rabbit ears will eventually break off, especially if you are launching it over hard ground. When they break off you can just consider it an Easter Egg Rocket.

The rocket is heavier then my other rockets, so it probably only goes about 30ish feet high, but it really depends on how hard you stomp it.

As always feel feel to remix the rocket or upload different coloring styles.