Summary

A lack table leg raiser and takes an elevator bolt to allow for table leveling and rubber mount for reduced table vibration.

*Additional tools needed
Wood Glue (optional)
Dremel / Drill (optional)
4x Dowel Pin (1 inch long and 1/4 inch diameter) [https://www.amazon.com/gp/product/B0055HPPSA/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1](https://www.amazon.com/gp/product/B0055HPPSA/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1) (optional)
4x Elevator bolt (~1 inch length, and wider on the foot is better, 3/8 inch / 9.5mm width on bolt) (optional)
4x Nut (3/8 inch) (optional)
4x Rubber (I used a rubber washer as it was cheap and fit the elevator bolt nicely) (optional)

*To Install
Print leg. Glue rubber to bottom of elevator bolt.

Take a dowel peg and mark 1/2 down with a pen. Take Lack table leg and mark center position. Drill a hole that will tightly fit the peg 1/2 down. Put some wood glue on the peg and insert into the Lack table leg. Insert other side of dowel pin into the print. Take nut and screw onto elevator bolt. Place bolt and screw and place into print. You may need to use a wrench to tighten the bolt or file the hole a bit. The design is meant to be a tight fit to ensure that weight of the table is transferred onto the bolt directly as well as through the nut. Do the same to the 3 other legs.

Place table where you will use it. Ensure the table is level (adjust the elevator bolts as needed). Make sure all elevator bolts are applying pressure on the ground.

You can just print this and attach it to the table leg. It wont be the most secure and you wont be able to adjust the height but it will work.

Print Settings

• Rafts:

Doesn't Matter

• Supports:

Doesn't Matter

• Infill:

30

• Notes:

Higher infil and thicker walls are recommended to ensure the bolt and nut don't damage the structure.