Stackable Sliding Lid Container

Need a seller licence? Here: [https://patreon.com/Pops3D](https://patreon.com/Pops3D)

• Medium Sized container

• No volume change

• Modern look

• Sliding Lid

• Stack-ability

• Interchangeable lids

• Print the container vertically with .2mm layer height or use my 3mf file

• Insert the lid though the tiny slots at the top of the box, be careful, there should be friction but not too much

• There is a very tiny lip that acts as a built in support, if it doesn't fall by itself, you need to remove it to be able to stack them

Q: Are there other sizes?

A: I plan on adding different sizes and making in modular, in the meantime, you should get away fine if you stretch it in the slicer to make it wider

Q: What if I want the lid to open more?

A: Lid is very thin, you could cut it with scissors to your liking

Q: What if they don't stack properly?

A: Check if you removed the tiny lip at the end of the container