I have not enabled a pause as I do in my other Hueforges .You will have to change the last color when red finishes (after the first 2 hours )  in AMS or enable a pause . Have Fun!

Project: Johnny 51.hfp
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.12mm

The Model is 187.75x200mm in size
You may print at higher layer heights below the Min Depth of 0.6mm
The Max Depth is 2.5mm and the Actual Depth is 2.5mm

Filaments Used:
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic Black Transmission Distance: 0.3
    PLA BambuLab Basic White Transmission Distance: 5
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA BambuLab basic Ice Blue Transmission Distance: 3.5
This print uses 5 unique filaments

Swap Instructions:
    Start with Red
    At layer #14 (0.64mm) swap to Black
    At layer #19 (0.84mm) swap to White
    At layer #32 (1.36mm) swap to Blue Gray
    At layer #41 (1.72mm) swap to Black
    At layer #51 (2.12mm) swap to Ice Blue for the rest.