If you do not want to use an AMS, just delete the filament changes and replace them with pauses instead.

There are two versions. One with a hole and one without. 

If you would like to sell my Hueforges a Commercial Licence subscription is available. Do not sell my prints without it please.

Important:

1. You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.
2. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). 
3. What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer.

You may see a floating regions error. This can be ignored.

Printing Instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Remember to select the correct plate type for your printer.

I have used a height range modifier in the object settings for quicker printing. The layer swap numbers in the print profile will not match the ones written below. Do not worry about this.

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.1
PLA BambuLab Basic Blue Gray Transmission Distance: 2.3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 6
 

Swap Instructions:
Start with Black
At layer #15 (1.28mm) swap to Blue Gray
At layer #17 (1.44mm) swap to Gray
At layer #19 (1.6mm) swap to Jade White for the rest.
 

Ratings are welcomed.

Give me a follow. :)