This Enclosure is designed to house electronic boards.

The model is highly configurable and incorporates;

• Mounting points for the electronics
• Movable vents, which can be switched off if not required
• One configurable power cord hole which can be moved to different faces or switched off if not required
• Lid mounting posts, which can be recessed
• The drill hold can also be configured so you could size it to allow insertion of PEM nuts

I've done a fair bit of testing and I think the generator is fairly solid, although it's not fully constrained so you can break it if you give it bad dimensions.

Let me know if you find anything really wrong with it and I can modify/fix it : )

Following feedback the new additions to the model are;

• Configurable power cord hole
• Ability to only generate the box or the hole, if the dimensions are too large to put both on the print plate
• The lid is now generated a lot closer to the box, to aid in generation of both parts on a single plate
• The vents can now be switched off if not required