Lid for my Stackable Jewelry Box - Flower No 1 — STL Grátis

Hey there,

a new Lid for my stackable Jewelry Box - Flower No. 01 is here!

Here is a lid extension for my stackable jewelry boxes.

The lid consists of two parts: the top part with the flower and the bottom part, which holds onto the box. The two parts are held together using my buttons for the box, meaning you can also use your "old" ones for this. Please make sure not to tighten them too much. If you have any issues, you can also use a bit of glue to ensure everything stays in place.

The part with the flower (HueForge) was created in my print profile so that it is applied to the lid and printed only where necessary at 0.08mm. My filaments and the colors I used are listed further down.

Here you can find all stackable jewelry boxes MIX & Match:

[https://makerworld.com/en/collections/3719067](https://makerworld.com/en/collections/3719067)

Here you can find all stands and lids for the boxes:

[https://makerworld.com/en/collections/3719078](https://makerworld.com/en/collections/3719078)

Here you can find all knobs for the lids of the boxes:

[https://makerworld.com/en/collections/3719084](https://makerworld.com/en/collections/3719084)

Used filament from the brand Polymaker

Panchroma - Charcoal Black (#2Colour Flower / #1Colour Lid)

Panchroma - Muted Blue (#1Colour Lid)

Panchroma - Muted Green (#1Colour Lid)

Panchroma - Sakura Pink (#3Colour Flower)

Panchroma - Pastel Mint (#3Colour Flower)