This was a fun design to create an Easter egg inspired fidget spinner. 

Do not scale. The scaling would mess up the bearing sizing. 

No bearings, no problems. My version used the printed version located here: [https://makerworld.com/en/models/473167#profileId-1062763](https://makerworld.com/en/models/473167#profileId-1062763) 

Plate 1: Plain egg

Plate 2: Dots

Plate 3: Stripes

Each plate has everything needed to create 1 fidget spinner. You can also mix and match the designs and use different colors for each block if desired. My choices for filament colors may have been better. Please post your easter themed styles. 

Installation instructions;

This design is a tight fit and is intended to snap all together without glue.  The interference fit means that the bearings will work as intended and not slip on installation. This means pressing in the bearings into the easter egg portions and along the shaft. You will have to press hard to get it on or use a screwdriver. I have created a little press to help assist. The main shaft has a brim on it so the slinger printers won't knock it down. If it doesn't come off cleanly a light sand on the edges of the rod will assist in assembly. Alternatively you could throw the bearings into the freezer and install the egg pieces fresh hot the press. Be careful. 

1. Each egg portion has a rim on the top portion for the 608 bearing to set in. You have to press a 608 bearing  into each. This will be the top. Flip each piece around. 

2. Start with the bottom. This is the flat piece and press the rod into it. 

3. Next place 2 collars on the rod. 

4. Place the bottom egg piece (#1)

5. Repeats steps 3 and 4 with the next two egg pieces

6. Add the thin collar piece to the top. 

7. Snap the top egg piece on 

8. Spin to your hearts content.

9. Rate and boost