Hedgehog to grow cress.

 In Poland where I live sowing cress is an Easter tradition. By the way, cress is a good addition to sandwiches and salads :)

Settings

For this project I used Bambu PLA Wood. I set the infill to 0%, but instead I increase the walls to 3. My goal was to seal the walls as much as possible since the cotton wool should be wet all the time. If the model leaks inside, simply make a hole in the foot and all the moisture should flow out. I also rotated the model so that it used as few supports as possible.

Instruction

After printing, apply soaked cotton wool to the hedgehog and sow some cress. 

Water regularly. I will update photos as the cress grows :)

If you liked this project, check out my cressling  creature as well.

[https://makerworld.com/pl/models/2585639-cress-creature-cressling#profileId-2852271](https://makerworld.com/pl/models/2585639-cress-creature-cressling#profileId-2852271)

Have Fun :)