Treat yourself—or surprise someone else—with this print-in-place “permanent” bracelet! 

A simple piece of filament forms the final link. Simply find the hole on the last link, insert some filament until it goes completely through the bracelet. You may need some assistance for this. Then, snip the filament to be flush with the side of the bracelet. 

You can leave it as is for a quick clasp, or permanently secure it using glue, a 3D pen, or by gently deforming the filament with a thumb tack.

🔹 The bracelet is available in three sizes (large, medium, and kid-friendly 140 mm)!
🔹 Supports not needed!
🔹 Great as a matching gift for two friends.

🔹 You can add or remove sets of 2 links in the slicer for a precise fit!

The medium size, which fits most adults,  even fits on a small A1 Mini.

 It’s designed for multi-color printing, but works great in a single color—no special profile needed. For extra fun and minimal waste, print a second bracelet as your purge block to nearly zero out any extra filament usage.

(NOTE: If you find you are having bed adhesion problems with this, you should consider using a smooth plate with bed adhesive! - Cheers)