Modular Stackable Shelving System

------------------------------------------------------------------------------

Fully customizable shelving. Snug fit design.

-----------------------

2 style of posts at 25mm height increment from 50 to 200 (clearance)

‘relatively stronk’ - the dumbbell pictured is 10lbs (tested with bambu pla basic), you can also add mid span posts for extra strength

-----------------------

Cap for top posts. Also included posts with reduced peg height for a flush top

-----------------------

Feet - 10 & 20mm height. And a 5mm to use as a floating mid span post anchor

-----------------------

2 style of base (rib & no rib) - Width at 60 increment from 60 to 240 - Length @ 120 & 240

The rib style base reduce height clearance by 5mm

Fit bambu filament spool cardboard box

(You need to do some mod to print the full size 240x240 base due to the interference with the front left purge area, bambu guide here)

(2 smaller bases in the picture are older versions)

Bambu wouldn't accept the large 240x240 base in the 3mf, so I have uploaded the model.

************************************************

TOLERANCES are 0.22mm & 0.15mm for the pegs (reg & top)

Works fine with 0.4mm nozzle, bambu pla basic & default line width for me.

************************************************

2024-01-13 REVISION 2 - plate 11 to 13

-----------------------

added 3 pegs posts (reg & slim) - all height

added 4 pegs posts (slim) - all height

************************************************

2024-01-20 REVISION 3 - plate 14 & 15

-----------------------

Added 5 vertical brace for when you need max sway protection - for height 100 to 200.

Stackable and as always - no support needed - pegs should slide right in just the way she likes it.

************************************************

2024-01-28 REVISION 4 - plate 16

-----------------------

Added offset posts - you can use the entire base plates surface with these.

Slim and regular - all heights.

01-28 pm - Forgot 2 add top holder/cap - plate 9

2024-01-30 - there was a slight error on the top holder/cap - fixed

************************************************

2024-05-03 REVISION 5 - plate 17 & 18

-----------------------

As requested by some users:

Added slim base 240x180 ribbed - save ~45% in filament - suitable for boxes or large item

Added vertical brace height 75 & 50

************************************************

2024-07-10 REVISION 6 - plate 19

-----------------------

Added offset top posts - reg & slim all heights and cap - this will allow for a flat top

************************************************

2025-04-08 REVISION 7

-----------------------

Added 3 pegs and 4 pegs feet & flush connector 

************************************************

2026-04-20 REVISION 8

-----------------------

Added railings - for plate width 60, 120, 180, 240.  

10 tall 2 thick - no support as always - Goes into the inner peg hole at the corner

 (*if your post setup take both holes on that edge, u need to cut 10mm off each end of the railings  

************************************************