I have before you, the levitating fidget button. You will need 2 10x3mm round magnets and a touch of super glue. The print profile has 2 pauses to insert magnets at the correct time. Make sure your magnets polarity is right and that the magnets are repelling each other. Personally, I put the 2 magnets together and mark each side with a permanent marker. This way I know if the mark is facing up everything is correct. When inserting the magnets, I found it best to add a single drop of glue in the hole then place magnet and hold for a few seconds. Be careful inserting the 2nd magnet, don't push down to hard the only thing holding the button is the supports. Again, don't forget the glue and make sure your magnets polarity is correct. They need to repel each other. After the print is finished, you will need to remove the supports. I found it best to use a small flat head screwdriver to pop them loss. Start from the bottom and work your way up. Thats it, you now have a levitating button. Just remember to double check everything. If you want that magnetic levitating fidget button. This is what you gotta do. Happy printing. Thank you.