This Model features a long tube in the center, allowing for scalability along the Z axis Enabling a print suitable for smaller printers.

Right on the blue dot

This Model can be utilized for a wide range of miniature figures, statues, and Gundam models. 

The slanted top eliminates the necessity for supports at the top, but supports will still be required at the bottom.

The entire model utilizes Around 100 grams of filament.

The model operates by stacking two to three cardboard spools. I would not recommend stacking more than three due to the risk of it toppling over.

The model should accommodate most cardboard spools.

The printing time is estimated to be around four hours. 

Tips A clean printbed is recommended to be washed with warm, soapy water. A craft glue stick, such as Elmer’s glue,It may be slightly more challenging to print on the A1 or A1 mini printer due to the bed’s movement in both forward and backward directions.

Additionally, it is advisable to avoid putting near a window unless a heat-resistant filament, such as ABS or PETG, is used. 

This model was designed using Fusion 360.