Hi!

Thank you for stopping in,

This was a fun project I have never done hard surface sculpting and learned alot while doing it. I hope that you enjoy, and if theres anything you see that I could improve on your feedback would be more than welcome.

Printing profile:

in this printing profile I tuned the speeds down quite a bit as I was worried about the stability of the blade and handle.

Assembly:

There are holes for the blade and the bottom blade in the handle for them to go into, the only slightly tricky thing is the side of the blade (silver piece) I just put it on after the blade is in the handle and moved it as far up as I could and line the point up with the line along the blade.

A bit of superglue while assembling will help keep the pieces where theyre supposed it be.

Filament:

I used Elegoo silk PLA for the blade and the side piece and Black bambu basic PLA for the handle

Again this is my first model of something like this so please feel free to give any feedback you have either through comments or a direct message. 

If you would like to support me it would mean the world to me.

[https://buymeacoffee.com/layeredvisions](https://buymeacoffee.com/layeredvisions)

patreon.com/LayeredVisions (commercial licensing)

Or leave me a boost.

Thank you!!!!