Version 2 has arrived! Please consider that any review before 18/04/2026 is from version 1 that is no longer available. I prefer to keep the same MakerWorld page so you can see that this project has been improved and that I work on making better designs with your feedback.With this new version, I tried to eliminate all the possible weak points from V1. After many attempts and a lot of testing, it's finally here. 
Please do not arrange the plate. Print like its on the profile and you will have no problems!

**************************************************************************************************
 

Here is another design I've made for my animals. It's a simple design, yet very important for them.

If you have a cat or a dog with back problems or arthritis problems, this helps them to eat since they do not have to bend to reach the bowl.

I've made this one with the height of my dog's mouth in a stand position (15 cm / 5'9 inches), but you can always modify the project so it fits your cat or dog's size. 

The size of the bowl I used (0.45L) on his project is about 13.5 cm or 5'3 Inches (you can make it smaller using negative parts, for example). It's printed on one plate, and after various attempts, I finally reached the final version I will use for my cats and dogs. I've tested it, and so far this is another project that is bulletproof, or should I say dogproof, at least, and oh boy, they do a real good stress test to the bowl when it's time to eat :D
 

If you have a dog or a cat, even without any health problems, you can still use this design because it will make them eat in a natural position.

If you have any suggestions, please tell me. I will try to help you as much as I can.

Print time is about 4 hours and uses about 85 grams of filament. They deserve it!

A1 Mini users you can print this but i advice print in 2 plates.

Thank you for your time and patience. Have great prints!