Commercial License With a Commercial License Membership, you gain the right to sell 3D prints made from my original designs. Available through Patreon.

Description

I needed to hang some pictures and as usual it's tough to get them at the exact height you want despite measuring over and over again.

I decided to try my hand at designing a simple hook which can be adjusted afterwards - to allow for those minor changes you always wish you could.

Note! I've designed the inserts to leave space in case your screw head doesn't fit flat in the hole.

Design includes the following:

• Wall plates
  • Single counter sunk screw
  • Double counter sunk screws
  • Two small holes for nails
• Insert
  • Straight edge
  • Angled edge
  • V shaped Edge extra close to wall (Perfect for hanging paintings with wire)
  • Screw-on hanger + hanging-screw
• Screw (To fasten the insert)
• Key (To fasten the screw)

What to print:

Print the wall plate and insert you desire. You'll need one of the small screws as well and if you lack a screwdriver you might want to print the simple key as well.

How to print:

• The plate contain all items and is set to “print by object” to allow you to print it all with separate colors without waste. 
• If you want to print in a single color you can set it back to “print by layer” in the “others” menu.

Remember to leave a review, I'd love to see your prints!

And check out my other models!