This is a big red button. There are two buttons in the print profile, a DO NOT PRESS button, and a blank red one. You can choose which one to print. For filament, I used Bambu Lab Pla Basic red and black for this. I used this spring generator to create the spring: [https://makerworld.com/en/models/1131125-spring-generator-parametric-compression-springs?from=search#profileId-1131439](https://makerworld.com/en/models/1131125-spring-generator-parametric-compression-springs?from=search#profileId-1131439)

you can use this to create longer springs for the button. To assemble the button, put the spring on the inner tube of the housing. Then, put the red button cap on top. To close it, take the final ring and screw it onto the bottom base.