Show your love for R2D2 and Star Wars with these R2D2 inspired Hoodie Drawstring beads.

They are about 22mm tall and the hole diameter should come out as approximately 4mm. If you are having trouble getting the string through the bead, try using a toothpick or a small hex key to push the string through.

I added three print profiles:

• Single colour
  • less than 4 grams of filament per set
  • easiest to print in about 23 minutes
• Colour changes by layer
  • approximately 4 grams of filament
  • you should be able to print this without AMS, just change the colours manually. (I thing this can be done with this print profile. Let me know in the comments if you are having trouble with this.)
• Full colour
  • Uses approximately 24 grams of filament and prints in 2:15 hours
  • I personally like this one the most. Print multiple at the same time to reduce waste and give away the extra beads.
• Also check out my BB8, Mando, Deathstar and Millennium Falcon inspired Drawstring beads 

They should all be very easy to print, but be sure to clean your buildplate for optimal adhesion.

You can also support my work on Ko-fi! 
Or, if you're interested in selling physical prints of my designs, check out my commercial license options there.