I wanted a better frame rate camera to monitor my prints. I mounted a Raspberry Pi Zero 2 W in my P1S and mounted an Arducam for Raspberry Pi Zero Camera into this housing into the corner. You can angle the housing whichever way you like. I mounted the Pi in the printer with a command strip and ran a cable out of the bottom (where the bento box filter cables run out) to power it. 

I monitor the feed via RTSP. I used these instructions for setting up the Pi: [https://james-batchelor.com/index.php/2023/11/10/install-mediamtx-on-raspbian-bookworm/](https://james-batchelor.com/index.php/2023/11/10/install-mediamtx-on-raspbian-bookworm/)