A1/A1 Mini Cable Spring Holder

Your printer cable is dragging on the bed like a sad snake. It's twisting, moving around, and generally being a nuisance while you're trying to print something decent.

This spring holder fixes that. Keeps your cable elevated at the right angle (not straight up like an antenna), sits securely on your A1 or A1 Mini, and doesn't slide around like every other "solution" you've tried.

Took way too many prototypes to get this right. The bottom grips the printer properly, the cable slots in without a fight, and everything stays where it's supposed to. Measured every millimeter with a caliper because eyeballing things is for amateurs.

V2 Coming Soon because apparently perfection takes multiple attempts.

Available in Three Sizes because your setup is probably different from everyone else's. Small, Medium, Large. Pick one, or print all three and feel fancy.

Installation (It's Not Rocket Science):

1. Slide cable into spring (above the rubber part)
2. Push spring down onto rubber part
3. Stop worrying about your cable

Technical Details

• Fits A1 and A1 Mini
• Material: PLA recommended
• Three sizes available
• Precision engineered (with actual measurements)