Inspired by the awesome Rugged Box by Whity, I created this less rugged parametric box. 
I wanted a setup that was just as useful, but for scenarios where a lot of ruggedness is not necessary. You can adjust the boxes width, depth and height, as well as screw size and length. If you want to input specific values, you'll need a free onshape account so you can make a copy of the document.

Open the model and customize

See last image in gallery for where to customize and export. 

Print profile

The .3mf file is for a 120x85x30 box (the box with drill bits is this size). 

This box uses:

• A lot less filament 
• Half the amount of hardware (screws)

Printing instruction

• Print the lid top down, and the latch on its side (see image from slicer in gallery). 
• Prints without supports.